Skip to main content

Introduction

Not the guide you are looking for?

Go back to the ⇤ Makers Kit Build Flow.

  1. M3x15 plastite screw M3x15 plastite screw
    • M3x15 plastite screw

  2. As usual, don't over-tighten ;-) These are specialty 'plastite' screws that resist vibrations. Tightening too much will only damage your parts.
    • As usual, don't over-tighten ;-)

    • These are specialty 'plastite' screws that resist vibrations. Tightening too much will only damage your parts.

  3. M3x12 M3x12
    • M3x12

  4. M3x12
    • M3x12

  5. Do NOT over-tighten. There's absolutely no need to tighten the screw with all your force. You could break your fan mount or even pull out the brass threaded insert from the x carriage. The springiness of the part will provide some pressure to resist vibrations, but only if you do not over-tighten the screw.
    • Do NOT over-tighten.

    • There's absolutely no need to tighten the screw with all your force. You could break your fan mount or even pull out the brass threaded insert from the x carriage.

    • The springiness of the part will provide some pressure to resist vibrations, but only if you do not over-tighten the screw.

    • (M3x12)

  6. Leave the zip tie a bit loose. The wire should be able to slide. Leave the zip tie a bit loose. The wire should be able to slide. Leave the zip tie a bit loose. The wire should be able to slide.
    • Leave the zip tie a bit loose. The wire should be able to slide.

  7. Plastite screws Plastite screws
    • Plastite screws

  8. M3x10 Jun 12, 2018 erratum alert: If you don't see any M3x10 in your kit, please use M3x12. They'll work just fine.
    • M3x10

    • Jun 12, 2018 erratum alert: If you don't see any M3x10 in your kit, please use M3x12. They'll work just fine.

  9. Marvel at your skills of assemblage. Marvel at your skills of assemblage. Marvel at your skills of assemblage.
    • Marvel at your skills of assemblage.

  10. M3x12 M3x12
    • M3x12

  11. M3x12
    • M3x12

  12. M3x12
    • M3x12

    • Preferably, tighten in the 'down' position.

    • Only tighten this screw lightly.

    • ▶ Video: JellyBOX 2 Build: X Mechanical Checkpoint #2

Conclusion

What's Next?

Get back to the ⇤ Makers Kit Build Flow and continue with the next guide.

Filip Goc

Member since: 01/14/2016

18,009 Reputation

490 Guides authored

Team

team curriculum Member of team curriculum

Community

2 Members

490 Guides authored

0 Comments

Add Comment