-
-
LCD controller
-
Acrylic Front
-
Acrylic Inner and Outer Spacer (2)
-
M3x25 flathead screws (4)
-
M3 washers (4)
-
M3 locknuts (4)
-
-
-
Slap the front onto the printer and secure with the green corner clips.
-
-
-
4'' zip tie
-
Do not over tighten. Leave quite loose.
-
The EXP 1 connector from the LCD needs to connect with the EXP 1 connector on RAMPS. (And EXP 2 matches EXP 2). Else the LCD will not turn on. (But neither it will get damaged.)
-
Almost done!
Finish Line
Cancel: I did not complete this guide.
One other person completed this guide.