03. Front

Written By: Filip Goc (and one other contributor)
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

15

Time Required

Suggest a time??

Sections

2

Flags

1

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

  1. Insert wisdom here. Insert wisdom here. Insert wisdom here.

    • Insert wisdom here.

    Edit
  2. Edit

  3. If there's a sticker on your LCD, you are encouraged to remove it for aesthetic reasons. If there's a sticker on your LCD, you are encouraged to remove it for aesthetic reasons.

    • If there's a sticker on your LCD, you are encouraged to remove it for aesthetic reasons.

    Edit

  4. M3x25 flat head (4x) M3 locknut (4x)

    • M3x25 flat head (4x)

    • M3 locknut (4x)

    Edit

  5. LCD spacer (4x) LCD spacer (4x)

    • LCD spacer (4x)

    Edit
  6. Edit
  7. Edit
  8. Edit

  9. Do NOT over-tighten. Do NOT over-tighten.

    • Do NOT over-tighten.

    Edit
  10. Edit
  11. Edit
  12. Edit
  13. Edit

  14. You need to match the connectors as shown, or the LCD will not work. There are a bit hard to read 'EXP1' and 'EXP2' markings around the connectors. If you mis-match the connectors, nothing bad happens! The LCD will not light up, but it will not get damaged. You can always just swap the connectors later when we test the whole printer.

    • You need to match the connectors as shown, or the LCD will not work.

    • There are a bit hard to read 'EXP1' and 'EXP2' markings around the connectors.

    • If you mis-match the connectors, nothing bad happens! The LCD will not light up, but it will not get damaged. You can always just swap the connectors later when we test the whole printer.

    Edit
  15. Edit
Finish Line

Author

with 1 other contributor

Filip Goc

Member since: 01/14/2016

18,037 Reputation

490 Guides authored

Team

team curriculum Member of team curriculum

2 Members

490 Guides authored

0 Comments

Add Comment