Difficulty
Moderate
Steps
8
Time Required
- ZX Coupler 8 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Video Overview
Video Walkthrough
-
-
ZX coupler
-
Trapezoidal flanged nut
-
M3x 12 bolt (2)
-
M3 serrated washer (2)
-
M3 hex key
-
-
-
Align the holes in the flange of the nut with the bolt holes in the ZX coupler.
-
-
-
Place the washers on the bolts.
-
Use the M3 hex key to screw in the bolts.
-
-
-
Place the ZX coupler on the Z axis leadscrew.
-
Screw the coupler down until it's near the bottom.
-
-
-
M3x45 socket screws (2)
-
M3 serrated washers (2)
-
M3 hex key
-
-
-
Put the serrated washers onto the bolts.
-
Thread the bolts into the top two holes on the X motor. Leave the bolts loose at this stage.
-
-
-
Loosen the bolts holding the Z motor.
-
This lets all the parts self align.
-
-
-
Use the M3 hex key to tighten the ZX coupler to the X motor.
-
Leave the bolts holding the Z motor to the Bottom loose - we'll tighten these later as a part of self-alignment procedure.
-
Team
