Skip to main content

Introduction

Not the guide you are looking for?

Go back to the ⇤ Makers Kit Build Flow.

  1. Rotate the Z rod to move the whole X assembly about this high. Rotate the Z rod to move the whole X assembly about this high.
    • Rotate the Z rod to move the whole X assembly about this high.

  2. Get some of that lithium grease from the little pack in the tools box.
    • Get some of that lithium grease from the little pack in the tools box.

  3. Apply the grease below the zx coupler. As the X assembly will travel up and down during future prints, it will distribute the grease.
    • Apply the grease below the zx coupler.

    • As the X assembly will travel up and down during future prints, it will distribute the grease.

Conclusion

What's Next?

Get back to the ⇤ Makers Kit Build Flow and continue with the next guide.

Filip Goc

Member since: 01/14/2016

18,009 Reputation

490 Guides authored

Team

team curriculum Member of team curriculum

Community

2 Members

490 Guides authored

0 Comments

Add Comment