01. Y Motor Bracket (easy kit)

M3x12

This piece is packed in together with the other acrylic parts in the big 'pizza' box.

Make sure the motor connector aligns with the etching.

Make sure you can read the inscription :-)

M3x12

When tightening against plastic (frame, printed parts...), always hold the short side of the hex key to avoid over-tightening and damaging the part.

Avoid alignment issues by tightening the screws little by little in a diagonal pattern.

This is called "cross-tightening", and you should do it every time* you have more than one screw to tighten.

* even when you're not building a JellyBOX

Note: the picture features an older version of the Y bracket. The technique remains.

▶ Video: Cross-Tightening (20s)

Note: the picture features an older version of the Y bracket. The technique remains.

The Y motor bracket is assembled. All the naysayers shall be silent now. You are doing this.