Video Overview
Video Walkthrough
-
-
Insert 4" zip ties with the head on the outside (facing you) anywhere where there is a pair of holes 'connected' with an etching.
-
Tip: It is more efficient to first drop all the zip ties in all the holes and then pull them all back through! Energize.
-
Note: two groups of 3 holes close to the center of inner back fit two zip ties - the middle hole is shared.
-
-
-
Align the wire comb with the corresponding annotations (ie. filament fan, heat block, etc.), and secure it with a zip tie.
-
Tip: Cut the zip ties connecting the wire comb immediately to reduce visual complexity.
-
Almost done!
Finish Line