Skip to main content

Introduction

Not the guide you are looking for?

Go back to the ⇤ Easy Kit Build Flow.

  1. M3x16
    • M3x16

  2. M3x16 M3x16
    • M3x16

  3. Avoid alignment issues by tightening the screws little by little in a diagonal pattern.
    • Avoid alignment issues by tightening the screws little by little in a diagonal pattern.

    • This is called "cross-tightening", and you should do it every time* you have more than one screw to tighten.

    • * even when you're not building a JellyBOX

    • Fancy a ▶ VIDEO?

  4. Tighten well. This is metal-on-metal tightening, so you do not have to be as gentle as usual.
    • Tighten well.

    • This is metal-on-metal tightening, so you do not have to be as gentle as usual.

  5. The position of the wedge on the belt is not precise - you only need to make sure to fit the belt teeth into the wedge teeth. The position of the wedge on the belt is not precise - you only need to make sure to fit the belt teeth into the wedge teeth. The position of the wedge on the belt is not precise - you only need to make sure to fit the belt teeth into the wedge teeth.
    • The position of the wedge on the belt is not precise - you only need to make sure to fit the belt teeth into the wedge teeth.

  6. You may cut off the excess if you wish.
    • You may cut off the excess if you wish.

    • ▶ Video: Secure the X Belt (25s)

    • ▶ Video: Clip the X Belt (35s)

  7. ≃ Leave a bit less than a centimeter (3/8 inch) of the x belt intact in case you ever need to dis-or-re-assembly your JellyBOX.
    • ≃ Leave a bit less than a centimeter (3/8 inch) of the x belt intact in case you ever need to dis-or-re-assembly your JellyBOX.

    • ▶ Video: X Mechanical Checkpoint #1

Conclusion

What's Next?

Get back to the ⇤ Easy Kit Build Flow and continue with the next guide.

Filip Goc

Member since: 01/14/2016

18,037 Reputation

490 Guides authored

Team

team curriculum Member of team curriculum

2 Members

490 Guides authored

0 Comments

Add Comment