Introduction
Not the guide you are looking for?
Go back to the ⇤ Makers Kit Build Flow.
-
-
You need to match the connectors as shown, or the LCD will not work.
-
There are a bit hard to read 'EXP1' and 'EXP2' markings around the connectors.
-
If you mis-match the connectors, nothing bad happens! The LCD will not light up, but it will not get damaged. You can always just swap the connectors later when we test the whole printer.
-
Almost done!
What's Next?
Get back to the ⇤ Makers Kit Build Flow and continue with the next guide.
Conclusion
What's Next?
Get back to the ⇤ Makers Kit Build Flow and continue with the next guide.