-
-
Tip: insert all zip ties first, then tighten them all at the same time.
-
It's much faster than inserting and tightening each zip tie separately.
-
-
-
Insert the Extruder into the X carriage.
-
Don't forget to connect all the wires.
-
Do not pinch the hotend wires. Make sure they go underneath the x carriage
-
Cancel: I did not complete this guide.
One other person completed this guide.
2 Comments
What about the side hole covers? Zip tie them on?
Also, the tip on 13 could use some directions. I don't think it is explained earlier.
# Side hole covers:
19 out of 20 users do not use them at. For some instances with little kids around and a specific printer placement, the side hole covers may help keeping them off the insides... so zip tie them in if you desire.
# Inserting the extruder:
There's an impromptu guide at the end of the X Assembly section. Assemble the X Assembly (direct link to the end of the guide)
I'll cross-post the video and add the warning about wires.
Thanks for your vigilantism Justin :-)