Skip to main content

Introduction

Not the guide you are looking for?

Go back to the ⇤ Makers Kit Build Flow.

    • ▶ Video: Coupler Spin (2s)

  1. Hold the X assembly up with one of your hands so that the holes are well aligned. Otherwise, the misalignment caused by gravity will make it difficult to screw in the screws. Otherwise, the misalignment caused by gravity will make it difficult to screw in the screws.
    • Hold the X assembly up with one of your hands so that the holes are well aligned.

    • Otherwise, the misalignment caused by gravity will make it difficult to screw in the screws.

  2. Make sure the  ZX  coupler and Z motor screws are LOOSE
    • Make sure the ZX coupler and Z motor screws are LOOSE

    • Put the printer on the edge of a table to expose the Z motor screws.

    • Rotate the Z lead screw by hand to find the Z motor position in which the movement is the smoothest.

    • Moderately tighten X screws.

    • Only lightly tighten Z screws. Tight is bad!

Conclusion

What's Next?

Get back to the ⇤ Makers Kit Build Flow and continue with the next guide.

Filip Goc

Member since: 01/14/2016

18,009 Reputation

490 Guides authored

Team

team curriculum Member of team curriculum

Community

2 Members

490 Guides authored

0 Comments

Add Comment