Introduction
Not the guide you are looking for?
Go back to the ⇤ Easy Kit Build Flow.
-
-
Put the printer on the edge of a table to expose the Z motor screws.
-
Rotate the Z lead screw by hand to find the Z motor position in which the movement is the smoothest.
-
Moderately tighten X screws.
-
Only lightly tighten Z screws. Tight is bad!
-
Almost done!
What's Next?
Get back to the ⇤ Easy Kit Build Flow and continue with the next guide.
Conclusion
What's Next?
Get back to the ⇤ Easy Kit Build Flow and continue with the next guide.