Introduction
Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction Introduction
Video Overview
-
-
The side of the pulley with grub screws should be facing away from the motor.
-
The pulley should be extending about 4mm beyond the edge of the motor shaft - as much as possible without the grub screws getting off the motor shaft.
-
-
-
Take out two set screws out of a pulley using a hex key.
-
Put a single small drop of thread lock onto the set screw thread.
-
Spread the thread lock into the thread. Do not use too much thread lock. Little is enough. Wipe excess if necessary. Tip: Keep the set screw on the hex key for easy manipulation.
-
-
-
Re-insert the set screws into the pulley. Repeat procedure for both set screws.
-
-
-
Slide the Y pulley onto the Y motor shaft.
-
The thin flange side of the pulley faces away from the motor - towards the top of the motor shaft.
-