Back

Back acrylic piece

Hexagonal acrylic mounts (3)

6" zip ties (9)

Corner clips (6)

Thread a 6" zip tie through each hexagonal mount.

(The toothy part of the zip tie should be facing the center point of the hexagonal piece.)

Critical The etchings on the back piece should be on the side facing you; that is, the text should look mirrored.

Attach the hexagonal mounts on top of the back with the zip ties.

Two mounts go on the left: at the top and bottom.

One mount goes at the right.

Use the six corner clips to attach the back panel to the box.

Use the last six 6" zip ties to fix the back in place.

Tip: Thread the ties towards you first will make it easier to tighten them.

Be careful of this knob when rotating the printer on its front for easier access.

If it gets pushed in, it won't turn properly; to remedy this simply pull it out again with vise grip.