Video Overview
Video Walkthrough
-
-
Back acrylic piece
-
Hexagonal acrylic mounts (3)
-
6" zip ties (9)
-
Corner clips (6)
-
-
-
Thread a 6" zip tie through each hexagonal mount.
-
(The toothy part of the zip tie should be facing the center point of the hexagonal piece.)
-
-
-
Critical The etchings on the back piece should be on the side facing you; that is, the text should look mirrored.
-
Attach the hexagonal mounts on top of the back with the zip ties.
-
Two mounts go on the left: at the top and bottom.
-
One mount goes at the right.
-
-
-
Use the last six 6" zip ties to fix the back in place.
-
Tip: Thread the ties towards you first will make it easier to tighten them.
-
-
-
Be careful of this knob when rotating the printer on its front for easier access.
-
If it gets pushed in, it won't turn properly; to remedy this simply pull it out again with vise grip.
-