Introduction
Warning: This guide features an old JellyBOX 1, while you are building JellyBOX 2.
While some parts look different, the principle is exactly the same and we believe you will be fine!
Not the guide you are looking for?
Go back to the ⇤ Easy Kit Build Flow.
-
-
There'a better guide in town for this section!
-
Please visit go.imade3.com/your-first-print for a more comprehensive and up to date guide on Calibrating your Z Probe and your First Print.
-
-
-
M3 screws
-
Move the filament fan and the Z probe above the nozzle.
-
Do not over-tighten these screws. No need. (Many people tend to over-tighten these screws.)
-
-
-
Turn the z lead screw with your bare hand until the nozzle is lightly touching the build plate.
-
A proven way to do this is by touch: when you can't move the paper freely back-and-forth that's when the nozzle is touching the plate.
-
You don't have to worry about being crazy precise. The important thing is that you're consistent. Just get a feel for the paper. In a few calibration cycles, you'll be a master.
-
What's Next?
Get back to the ⇤ Easy Kit Build Flow and continue with the next guide.
What's Next?
Get back to the ⇤ Easy Kit Build Flow and continue with the next guide.