Video Overview
Video Walkthrough
-
-
30mm fan with a short wire (1)
-
Right fan shroud (1)
-
Larger fan mount (1)
-
Plastite screws (5)
-
Proximity Sensor (1)
-
M3x16 bolts (2)
-
M3 regular washers (2)
-
M3 nylon locknuts (2)
-
-
-
Attach the large mount onto the side of the shroud with one plastite screw.
-
Attach the fan onto the shroud
-
As before, tighten the plastite screws in a cross pattern.
-
The fan wire should be exiting at the top right when you're looking directly at the shroud; running parallel to the mount. (Consult video if needed)
-
-
-
Attach the sensor to the bottom of the mount with two M3x16 screws.
-
Tighten with two M3 regular washers and M3 nylon locknuts. The bolt heads should be on the sensor side.
-
-
-
X Assembly (1)
-
Right Fan Assembly (1)
-
M3x16 bolt (1)
-
M3 regular washer (1)
-
M3 regular bolt (1)
-
-
-
We repeat the procedure we used for the left fan, but with a longer bolt.
-
Place a washer onto the M3x16 bolt and insert it into the slot on the fan mount.
-
Place a regular M3 nut into the slot on the right side of the carriage.
-
Insert the bolt and tighten with an M3 hex key.
-
-
-
Short Spacer (1)
-
Long Spacer (1)
-
M3x45 bolt (1)
-
M3x60 bolt (1)
-
M3 regular washer (4)
-
M3 nylon lock nut (2)
-
-
-
Put an M3 washer onto the M3x60 bolt. I
-
nsert the M3x60 into the hole at the top left of the X assembly acrylic.
-
Slide the long spacer onto the bolt with the grooved end pointing away from the assembly.
-
Place another washer and an M3 nylon lock nut onto the bolt.
-
Tighten it up with a wrench and an M3 hex key. The image may look confusing because you can see through the acrylic. Consult the video walkthrough if necessary.
-
-
-
As before with the longer spacer, place an M3 washer onto the M3x45 bolt.
-
Insert the bolt through the hole on top of the X carriage.
-
Add the short spacer, grooved end pointing away.
-
Add the M3 washer and M3 nylon lock nut, and tighten with a wrench and M3 hex key.
-