-
-
Put the printer on the edge of a table to expose the Z motor screws.
-
Rotate the Z lead screw by hand to find the Z motor position in which the movement is the smoothest.
-
Moderately tighten X screws.
-
Only lightly tighten Z screws. Tight is bad!
-
Almost done!
Finish Line
2 Comments
It may be helpful to turn the “Finish Line” into a link to the next step. We have had trouble getting to the correct next step in the otherwise great instructions.
Mine was preassembled. Not sure if that’s the plan.
Joel Bonasera - Reply
We’ll see :-)
Filip Goc -