Difficulty
Moderate
Steps
1
Time Required
- ↳ X Homing Offset 1 step
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Introduction
The X Homing offset tells the printer where the print area (build plate) effectively starts as the "home position" for x – the place at which X carriage hits the X endstop – puts the nozzle off the build plate.
If the offset isn't set, under some conditions, the proximity sensor may cause problems trying to sense off the edge of the plate.
-
-
Settings > X Homing Offset
-
X Homing Offset = "10" = 10mm
-
Y homing Offset = "0" = 0mm
-
Cancel: I did not complete this guide.
3 other people completed this guide.
Team
