Skip to main content

Trouble Printing from Tinkercad

HI! I’m a high school librarian and trying to get 3D printing implemented into the library. I’m very new to 3D printing and learning as I go. I created a small project in tinkercad. It stopped in the middle of printing it the first time I tried. I got a Heater Runaway Printing Halted Reset message. The second time I tried to print the project, it gave the same message from the start. Any suggestions on what I am doing wrong?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi @ghslibrarylady ,


Does your JellyBOX actually say ‘heater runaway’ or does it say ‘thermal runway?’ What’s the exact error message?

  • At any rate, this points to issues with the heating and/ or temperature reporting.
  • PS: Do you have a heated bed?

Here’s a litttle write up on Thermal Runaway issues on our forum:

https://forum.imade3d.com/t/what-is-the-...


Let me know how the troubleshooting goes.


Best,

~FIlip

Was this answer helpful?

Score 0
Add a comment

Add your answer

Lynn will be eternally grateful.